Lenovo ThinkSystem SR650 V2 - Page 108

User Action:
Check whether the chassis is opened or not properly sealed. If this is not an expected behavior, check
your asset.
• FQXSPSE2000I: The Chassis [PhysicalPackageElementName] was closed.
This message is for the use case when a Chassis has been closed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0005
User Action:
Information only; no action is required.
• FQXSPSE4000I: Certificate Authority [arg1] has detected a [arg2] Certificate Error.
This message is for the use case when there is an error with an SSL Server, SSL Client, or SSL Trusted CA
Certificate.
Severity: Error
Serviceable: No
Automatically notify Support: No
Alert Category: System - other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0002
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the certificate that you are importing is correct and properly generated.
2. If problem persists, collect Service Data log.
3. Contact Lenovo Support.
• FQXSPSE4001I: Remote Login Successful. Login ID: [arg1] using [arg2] from [arg3] at IP address
[arg4].
This message is for the use case where a user successfully logs in to a Management Controller.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0014
User Action:
Information only; no action is required.
• FQXSPSE4002I: Security: Userid: [arg1] using [arg2] had [arg3] login failures from WEB client at IP
address [arg4].
This message is for the use case where a user has failed to log in to a Management Controller from a web
browser.
104
ThinkSystem SR650 V2 Messages and Codes Reference