Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPUN0019M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPUN0020N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPUN0023N Sensor [SensorElementName] has transitioned to non-recoverable. Error
FQXSPUN0050M The RAID controller in PCI slot [arg1] is in critical state. At least one
logical drive is offline.
Error
FQXSPUN0053M The RAID controller in PCI slot [arg1] is in critical status. At least one
physical drive is failed.
Error
FQXSPUN0054M The RAID controller in PCI slot [arg1] is in critical status. At least one
logical drive is now degraded or partially degraded.
Error
FQXSPUN0055M The RAID controller in PCI slot [arg1] is in critical state. Battery is in
non-optimal state.
Error
FQXSPUP0007L Invalid or Unsupported firmware or software was detected on system
[ComputerSystemElementName].
Error
FQXSPUP4000I Please ensure that the Management Controller [arg1] is flashed with
the correct firmware. The Management Controller is unable to match
its firmware to the server.
Error
FQXSPUP4003I [arg1] firmware mismatch internal to system [arg2]. Please attempt to
flash the [arg3] firmware.
Error
FQXSPUP4004I XCC firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the XCC firmware to the same level on all
nodes/servers.
Error
FQXSPUP4005I FPGA firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the FPGA firmware to the same level on all
nodes/servers.
Error
List of XClarity Controller events
This section lists all messages that can be sent from the XClarity Controller.
• FQXSPBR4000I: Management Controller [arg1]: Configuration restored from a file by user [arg2].
This message is for the use case where a user restores a Management Controller configuration from a file.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0027
User Action:
Information only; no action is required.
• FQXSPBR4001I: Running the backup Management Controller [arg1] main application.
This message is for the use case where a Management Controller has resorted to running the backup
main application.
22
ThinkSystem SR650 V2 Messages and Codes Reference
To Next Page
Loading...
