Figure 108. Installing the middle drive cage and drives
a. Align the pins on the middle cage with the corresponding slots on the chassis.
b.
Lower the drive cage down into place.
c.
Install drives into the middle drive cage.
d.
Press the latch as shown and close the handle.
Step 5. Connect cables from the drive backplanes to the system board assembly or RAID/HBA adapters.
See
Chapter 6 “Internal cable routing” on page 271.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 269.
OCP module replacement
An OCP module is located on the rear or front of the server. Follow instructions in this section to remove and
install the OCP module.
•
“Remove the OCP module” on page 149
• “Install the OCP module” on page 151
Remove the OCP module
Follow instructions in this section to remove the OCP module.
About this task
CAUTION:
Power off the server and disconnect all power cords from their power sources before performing this
procedure.
Chapter 5. Hardware replacement procedures 149
To Next Page
Loading...
