Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Remove the OCP module filler if there is.
Step 3. Install the OCP module.
Note: Ensure that the Ethernet adapter is fully seated and the thumbscrew is securely tightened.
Otherwise, the OCP module will not get full connection and may not function.
Figure 112. OCP module installation
a. Push the OCP module into the slot until it is fully seated.
b.
Tighten the thumbscrew to secure the card.
Step 4. Attach the OCP label to the rear of the server.
Figure 113. Attaching the OCP label
After you finish
152 ThinkSystem SR650 V3 User Guide
To Next Page
Loading...
