Rack front
Figure 31. Lifting up the server
1
Lift point
Step 3. From the front of the rack, install server into the rails.
Attention: You can only install the server successfully when the rails are fully extended.
Rack front
Figure 32. Installing the server into the rails
a. Tilt the server and slowly lower its rear end; then, push the rails toward the server and make
sure the farthest nailheads on server’s left and right side go into the slots on the rail.
b.
Slowly lower the server down and make sure the other 3 nailheads on server’s left and right
sides slip into corresponding slots.
Note: Inspect the sides of the rails to make sure the nailheads are placed in the slots.
Chapter 5. Hardware replacement procedures 79
To Next Page
Loading...
