NVMe cable routing
Figure 124. Cable routing when one processor installed
From To
1 Backplane 1: NVMe 0-1, 2-3
1 Onboard: PCIe 1, 2
2 Backplane 1: NVMe 4-5, 6-7
2 Onboard: PCIe 3, 4
6 x SAS/SATA + 2 x NVMe
This topic provides cable routing information for the configuration with 6 SAS/SATA + 2 x NVMe front drive
bays.
To connect power cables for the front backplane(s), refer to
“Backplanes: server models with 2.5-inch front
drive bays” on page 163
.
To connect signal cables for the backplane(s), refer to the following cable routing scenarios depending on
your server configuration.
•
“8i/16i RAID/HBA adapter” on page 173
Chapter 6. Internal cable routing 171
To Next Page
Loading...
