Procedure
Step 1. If the server is installed in a rack, remove the server from the rack. See the Rack Installation Guide
that comes with the rail kit for your server.
Step 2. Remove the top cover.
Attention: Handle the top cover carefully. Dropping the top cover with the cover latch open might
damage the cover latch.
Figure 51. Top cover removal
a. Use a screwdriver to turn the cover lock to the unlocked position as shown.
b. Press the release button on the cover latch and then fully open the cover latch.
c. Slide the top cover to the rear until it is disengaged from the chassis. Then, lift the top cover off
the chassis and place the top cover on a flat clean surface.
Remove the air baffle
Use this information to remove the air baffle. If you intend to install hardware options in the server, you must
first remove the air baffle from the server.
About this task
S033
CAUTION:
Chapter 4. Server hardware setup 155
To Next Page
Loading...
