Step 3. Install the 2.5-inch-drive front backplane.
Figure 62. 2.5-inch-drive backplane installation
a. Align the bottom of the backplane in the slots on the bottom of the chassis.
b. Rotate the backplane to the vertical position and align the holes in the backplane with the pins
on the chassis and press the backplane into position. The release tabs will secure the
backplane in place.
Step 4. Connect the cables to the system board. See “2.5-inch/3.5-inch drive backplane (power)” on page
70 and “2.5-inch/3.5-inch drive backplane (signal)” on page 75.
Install the front 3.5-inch-drive backplane
Use this information to install the front 3.5-inch-drive backplane.
About this task
Your server supports one SAS/SATA 12-bay backplane.
Attention:
Chapter 4. Server hardware setup 169
To Next Page
Loading...
