Step 3. Install the 7mm drive backplane at the bottom.
Figure 68. 7mm drive backplane installation (bottom)
a. Align the pin on the cage and slightly slide the backplane into the cage until it is fully seated.
b. Install the screw as shown.
Step 4. Install the 7mm drive backplane on the top.
Figure 69. 7mm drive backplane installation (top)
a. Put the backplane down on the cage as shown.
b. Install the two screws to secure the backplane in place
Step 5. Connect the cables to the system board. See “7mm drives” on page 68.
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays.
Install cable wall brackets
Use this information to install the full-height or half-height cable wall brackets.
About this task
176 ThinkSystem SR665 Setup Guide
To Next Page
Loading...
