Figure 79.
Step 3. Check and ensure that the blue plungers are latched into place to secure the rear drive cage.
After you finish
1. Install the drives or drive fillers into the rear drive cage. See “Install a hot-swap drive” on page 197.
2. Connect cables to the rear drive cage. See Chapter 3 “Internal cable routing” on page 61.
Install the 4 x 2.5-inch rear drive cage
Use this information to install the 4 x 2.5-inch rear drive cage.
About this task
The rear drive cage is supported on some server models at certain conditions. For detailed information, see
“Drive bay configurations and requirements” on page 143.
Attention:
• Read “Installation Guidelines” on page 134 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Chapter 4. Server hardware setup 191
To Next Page
Loading...
