Step 3. Locate the connector on the M.2 adapter.
Note: Some M.2 adapters support two identical M.2 drives. Install the M.2 drive in slot 0 first.
Figure 86. M.2 drive slot
1 Slot 0
2 Slot 1
Step 4. Install the M.2 adapter into the M.2 tray.
Figure 87. M.2 adapter installation
a. Open the retention clip on the air baffle.
b. Insert the M.2 adapter at an angle of approximately 30 degrees into the tray as shown.
c. Rotate the M.2 adapter downward until it snaps into place.
Chapter 4. Server hardware setup 201
To Next Page
Loading...
