Step 5. Install the M.2 drive on the M.2 adapter.
Figure 88. M.2 drive installation
a. Insert the M.2 drive at an angle of approximately 30 degrees into the connector.
b. Rotate the M.2 drive down until the notch
1 catches on the lip of the retainer 2 .
c. Slide the retainer forward (toward the connector) to secure the M.2 drive into place.
Step 6. Connect the cables to the system board. See “M.2 drives” on page 69.
After you finish
Use the Lenovo XClarity Provisioning Manager to configure the RAID. For more information, see:
https://sysmgt.lenovofiles.com/help/topic/LXPMv3/LXPMv3_introduction.html.
202
ThinkSystem SR665 Setup Guide
To Next Page
Loading...
