Step 5. Install a riser 1 assembly or riser 2 assembly. The illustration shows installing the riser 1 assemblies.
The procedure is the same for installing riser 2 assemblies.
Figure 93. Riser 1 assembly installation (three-slot bracket)
Figure 94. Riser 1 assembly installation (one-slot riser bracket)
a. Align the riser adapter in the riser cage with the PCIe riser slot on the system board. Carefully
press the PCIe adapter straight into the slot until it is securely seated and its bracket also is
secured.
b. (Optional) If there is one screw on the riser cage, tighten the screw.
After you finish
Refer to Chapter 3 “Internal cable routing” on page 61 to connect any cables to the PCIe adapters.
Chapter 4. Server hardware setup 207
To Next Page
Loading...
