Procedure
Step 1. Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2. Install a riser card in a riser cage.
Figure 165. Riser card installation (three-slot riser bracket)
Figure 166. Riser card installation (one-slot or two-slot riser bracket)
1. Align the holes in the riser card with the mounting studs on the bracket. Install the riser card to
the bracket in the direction as shown.
2. Install the two screws to secure the riser card to the bracket.
Chapter 4. Hardware replacement procedures 351
To Next Page
Loading...
