Table 3. Events organized by severity (continued)
Event ID
Message String Severity
FQXSFDD0004M DRIVER HEALTH PROTOCOL: Reports 'System Shutdown' Required
Controller.
Error
FQXSFDD0012K SATA Hard Drive Error: [arg1].
Error
FQXSFIO0010M An Uncorrectable PCIe Error has Occurred at Bus [arg1] Device [arg2]
Function [arg3]. The Vendor ID for the device is [arg4] and the Device
ID is [arg5]. The physical [arg6] number is [arg7].
Error
FQXSFIO0011M A PCIe parity error has occurred on Bus [arg1] Device [arg2] Function
[arg3]. The Vendor ID for the device is [arg4] and the Device ID is
[arg5]. The Physical slot number is [arg6].
Error
FQXSFIO0012M A PCIe system error has occurred on Bus [arg1] Device [arg2]
Function [arg3]. The Vendor ID for the device is [arg4] and the Device
ID is [arg5]. The Physical slot number is [arg6].
Error
FQXSFIO0014J A bad option ROM checksum was detected for the device found at
Bus [arg1] Device [arg2] Function [arg3]. The Vendor ID for the device
is [arg4] and the Device ID is [arg5]. The physical slot number is [arg6].
Error
FQXSFIO0017M IFM: Error communicating with the XCC - IFM may not be deployed
correctly.
Error
FQXSFIO0019J PCIe Resource Conflict.
Error
FQXSFIO0024J PCIe Link Training Failure has occurred in physical [arg1] number
[arg2].
Error
FQXSFIO0030M Uncorrectable CPU link error has been detected on processor [arg1]. Error
FQXSFIO0042N An uncorrectable USB error (Type [arg1]) is detected on processor
[arg2] USB controller [arg3].
Error
FQXSFMA0001M DIMM [arg1] has been disabled due to an error detected during POST.
[arg2]
Error
FQXSFMA0002M An uncorrectable memory error has been detected on DIMM [arg1] at
address [arg2]. [arg3]
Error
FQXSFMA0008M DIMM [arg1] has failed the POST memory test. [arg2]
Error
FQXSFMA0027K Invalid memory configuration (Unsupported DIMM Population)
detected. Please verify memory configuration is valid.
Error
FQXSFPU0019N An uncorrectable error has been detected on processor [arg1].
Error
FQXSFPU0030N A firmware fault has been detected in the UEFI image. Error
FQXSFPU0031N The number of POST attempts has reached the value configured in F1
setup. The system has booted with default UEFI settings. User
specified settings have been preserved and will be used on
subsequent boots unless modified before rebooting.
Error
FQXSFPU0034L The TPM could not be initialized properly. Error
FQXSFPU0063N CPU [arg1] cores [arg2] disabled.
Error
FQXSFPU4056M TPM card is changed, need install back the original TPM card which
shipped with the system.
Error
FQXSFSM0008M
Boot permission timeout detected. Error
Chapter 3. UEFI events 165
To Next Page
Loading...
