• FQXSFIO0024J: PCIe Link Training Failure has occurred in physical [arg1] number [arg2].
Severity: Error
Parameters:
[arg1] Slot/bay
[arg2] Instance number
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable device driver, firmware update, version of service
information for this product or other information that applies to this error. Load new device driver and
any required firmware updates.
2. If this device and/or any attached cables were recently installed, moved, serviced or upgraded.
a. Reseat adapter or disk and any attached cables.
b. Reload Device Driver.
c. If device is not recognized, reconfiguring slot to lower speed may be required. Gen1/Gen2/Gen3
settings can be configured via F1 Setup -> System Settings -> Devices and I/O Ports ->PCIe
Gen1/Gen2/Gen3/Gen4 Speed Selection, or the OneCLI utility.
d. If a PCIe error has also been reported on a second slot within the same node, please ensure steps
a, b, and c above are also performed for that adapter or disk before proceeding.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFIO0027I: The Bus:[arg1] Device:[arg2] Fun:[arg3] is attempted to boot PXE.
Severity: Info
Parameters:
[arg1] Bus
[arg2] Device
[arg3] Function
User Action:
Information only; no action is required.
• FQXSFIO0029G: Correctable CPU link error has been detected on processor [arg1].
Severity: Warning
Parameters:
[arg1] Cpu Silk screen label, 1-based
User Action:
Complete the following steps:
1. Reboot the system.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFIO0030M: Uncorrectable CPU link error has been detected on processor [arg1].
Severity: Error
Chapter 3. UEFI events 173
To Next Page
Loading...
