User Action:
Complete the following steps until the problem is solved:
1. Make sure that the certificate that you are importing is correct and properly generated / certificate
CSR is correct
2. If problem persists, collect Service Data log.
3. Contact Lenovo Support.
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps.
2. Check Lenovo support site for an applicable service bulletin or firmware update for the system or adapter that
applies to this error.
3. If problem persists, escalate to next level of support.
• FQXSPSE4007I: Security: Userid: [arg1] using [arg2] had [arg3] login failures from an SSH client at
IP address [arg4].
This message is for the use case where a user has failed to log in to a Management Controller from SSH.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0041
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the correct login ID and password are being used.
2. Have the system administrator reset the login ID or password.
Service Action:
Information only; no action is required.
• FQXSPSE4008I: SNMPv1 [arg1] set by user [arg2]: Name=[arg3], AccessType=[arg4], Address=
[arg5], .
A user changed the SNMP community string
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0075
User Action:
Information only; no action is required.
Chapter 2. XClarity Controller events 149
To Next Page
Loading...
