Figure 123. Lock on the top cover latch
Table 43. Lock/unlock directions on the top cover latch
1 Unlock 2 Lock
Step 2. Press and hold on the blue tab of cover release latch; then, rotate the tip of the latch up.
Step 3. Push the latch forward to slide the top cover away from the server.
Figure 124. Top cover removal
Step 4. Lift the cover, remove it from the server, and set it aside.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the top cover
Use this procedure to install the server top cover.
S014
CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is
authorized to remove the covers where the following label is attached.
S033
Chapter 3. Hardware replacement procedures 131
To Next Page
Loading...
