Figure 63. LOM adapter assembly
To install the LOM adapter, complete the following steps:
Step 1. Open the retention latch.
Step 2. Align the LOM adapter to the connector, and push it in.
Step 3. Tighten the captive thumbscrew to lock it to the system board.
Figure 64. LOM adapter installation
Step 4. Close the retention latch.
After installing the LOM adapter, complete the following steps:
1. Reinstall the top cover (see “Install the top cover” on page 131).
2. Reconnect the power cords and any cables that you removed.
Chapter 3. Hardware replacement procedures 73
To Next Page
Loading...
