Lenovo ThinkSystem SR860 - Page 110

2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
3. Remove the top cover (see
“Remove the top cover” on page 89).
4. Remove the system board air baffle (see
“Remove the system board air baffle and the power interposer”
on page 94
) or the processor and memory expansion tray and the processor and memory expansion tray
air baffle (see
“Remove the processor and memory expansion tray” on page 96).
Figure 62. Processor locations
Table 77. Processor locations
1 Processor 3 3 Processor 1
2 Processor 4 4 Processor 2
Complete the following steps to install a PHM.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/watch?v=pIb0bIyfkDY&=
PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
.
Step 1. Remove the processor socket cover, if one is installed on the processor socket, by placing your
fingers in the half-circles at each end of the cover and lifting it from the system board.
Step 2. Install the processor-heat-sink module on the system board.
102 ThinkSystem SR860 Setup Guide