Lenovo ThinkSystem SR860 - Page 116

• SATA/SAS hard-disk drive
For a complete list of supported optional device for this server, see
https://static.lenovo.com/us/en/
serverproven/index.shtml
.
Before installing a 2.5-inch hot-swap drive:
1. Read the safety information and installation guidelines (see
“Safety” on page iii and “Installation
Guidelines” on page 56
).
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install a 2.5-inch drive, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/watch?v=pIb0bIyfkDY&=
PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
.
Step 1. Determine the available drive bays based on the drive bay labels applied. The following labels
indicate that the drive bays support both NVMe and SATA/SAS drives. Otherwise, only SATA/SAS
drives are supported.
Figure 67. Drive bay labels of both NVMe and SATA/SAS drives
Table 79. Drive bay labels of both NVMe and SATA/SAS drives
1 Drive bay 4-7 label of both NVMe and SATA/SAS
drives
2 Drive bay 12-15 label of both NVMe and SATA/
SAS drives
Notes:
1. Make sure to install the correct type of drives into supported by corresponding drive bays.
Drive type information is available on the drive.
Step 2. Remove the drive bay filler if it has been installed in the drive bay.
Step 3. Gently rotate the release latch away to unlock the drive handle.
Step 4. Slide the drive into the drive bay, and push it until it stops.
108
ThinkSystem SR860 Setup Guide