Figure 84. Removing USB 3.0 connector vertically
Step 3. Remove the USB 3.0 cable from the cable guide.
Step 4. Loosen the screw that secures the tray assembly.
Step 5. Push the tray assembly slightly out of the server; then; grasp it from the front and pull it out from the
server.
Figure 85. Operator panel tray assembly removal
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the operator panel tray assembly
Use this procedure to install the operator panel tray assembly.
Before installing the operator panel tray assembly:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
Chapter 3. Hardware replacement procedures 93
To Next Page
Loading...
