• Optional devices available for your system might have specific processor requirements. See the
documentation that comes with the optional device for information.
Before installing a PHM:
Note: The PHM for your system might be different than the PHM shown in the illustrations.
1. Remove the front cover. See “Remove the front cover” on page 139.
2. Remove the compute tray where the compute system board is installed. See “Remove a compute tray”
on page 123.
3. If you are installing a PHM in the lower compute system board, remove the upper compute system
board or compute system board filler. See “Remove a compute system board” on page 126.
Figure 25. Processor locations on system board
Figure 26. Processor layout for multi-processor systems (viewed from front of server)
Complete the following steps to install a PHM.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
52 ThinkSystem SR950 Setup Guide
To Next Page
Loading...
