Figure 31. Disconnecting the cable from the SATA hard disk drive connector
Step 3. Remove the drive cage from the chassis.
a.
Press and hold the drive cage release latch.
b.
Carefully slide the drive cage out of the chassis.
Figure 32. Removing the drive cage
Step 4. Remove the backplane or backplate (see “Remove the 3.5-inch/2.5-inch hot-swap drive
backplane” on page 92 or “Remove the 3.5-inch simple-swap drive backplate” on page 96).
After this task is completed
90 ThinkSystem ST250 V2 Maintenance Manual
To Next Page
Loading...
