A video of this procedure is available at YouTube: https://youtube.com/playlist?list=PLYV5R7hVcs-
DoEcxrm2zKNpaKOdZ3f8Qc
.
Procedure
Step 1. If there is a power supply bay filler installed, remove it.
Important: During normal operation, each power supply bay must contain either a power supply or
power supply filler for proper cooling.
Figure 105. Removing a hot-swap power supply filler
Step 2. Note the orientation of the hot-swap power supply, and then slide it into the chassis until it snaps
into place.
182
ThinkSystem ST250 V2 Maintenance Manual
To Next Page
Loading...
