Figure 50. Installing a 3.5-inch drive to the drive cage
Note: Depending on the configuration, the 3.5-inch drive may be the model in the illustration
below.
After you finish
1. Install the optical drive cage, see “Install the optical drive cage” on page 77.
2. Connect the signal and power cable to the system board, see “Internal cable routing” on page 19.
3. Check the drive activity LED on the front panel to verify if the drives are operating correctly.
Table 29. Drive activity LED behavior
Status Color
Description
Solid on
White The drives are active.
Off
None The drives are not active.
4. Use the Lenovo XClarity Provisioning Manager Lite to configure the RAID if necessary. For more
information, see
https://sysmgt.lenovofiles.com/help/topic/LXPML/RAID_setup.html.
Install the drive cage (bay 3)
Follow this procedure to install the drive cage to bay 3.
68 ThinkSystem ST50 V2 Setup Guide
To Next Page
Loading...
