Server models with four 3.5-inch hot-swap drives
Use this section to understand the cable routing for server models with four 3.5-inch hot-swap SAS/SATA
drives.
Server model: four 3.5-inch SAS/SATA drives, one 8i RAID adapter
Notes:
• Ensure that all cables are routed through the correct cable clips.
• Broken lines indicate the hidden parts.
Figure 28. Cable routing for server models with four 3.5-inch SAS/SATA drives and one 8i RAID adapter
Cable From To
1 SAS signal cable SAS connector on the backplane C0 connector on the 8i RAID adapter
2 Power cable Power connector on the backplane Backplane 1 power connector on the
system board
48 ThinkSystem ST550 Maintenance Manual
To Next Page
Loading...
