remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read “Installation guidelines” on page 57 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
The following notes describe the type of drives that your server supports and other information that you must
consider when you install a drive.
• For a complete list of supported optional devices for the server, see:
https://static.lenovo.com/us/en/
serverproven/index.shtml
• The drive bays are numbered to indicate the installation order (starting from number “0”). Follow the
installation order when you install a drive. See “Front view” on page 16.
• The drives in a single RAID array must be the same type, same size, and same capacity.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. If the drive bay has a drive filler installed, remove it. Keep the drive filler in a safe place for future
use.
Step 2. Install the simple-swap drive.
Figure 50. 3.5-inch simple-swap drive installation
a.
Ensure that the tray handle is in the open position. Align the drive with the guide rails in the
bay; then, gently push the drive into the bay until the drive stops.
b.
Close the tray handle to lock the drive in place.
After you finish
1. Install other drives or drive fillers if necessary.
82
ThinkSystem ST650 V2 Maintenance Manual
To Next Page
Loading...
