Electrical installation
Devices i n the power range from 0.37 to 3 kW (3/PE AC 400 V)
Terminal assignment of the power connections
6
70
EDS84ABD302 EN 4.0
Motor c onnection
Terminal X105 Labelling Description
U, V, W Motor
PE PE conductor
84BDGG012
Terminal data
Max. conductor cross-section Tightening torque
[mm
2
] [AWG] [Nm] [lb-in]
E84AVBxE3714
1 ... 2.5
18 ... 12 0.5 4.5 3.5 x 0.6
E84AVBxE5514
E84AVBxE7514
E84AVBxE1124
E84AVBxE1524
E84AVBxE2224
E84AVBxE3024
Connection of external brake resistor
X109
84BLDGG020
Fig. 6-14 Inserting terminal X109
Before plugging in the terminal X109:
1. Switch off the controller and wait for at least 3 minutes before start working.
2. Make sure that there is no residual voltage.
3. Pull the cover carefully to the side without removing it completely.
4. Plug in the terminal.
To Next Page
Loading...
