Lenze 8400 BaseLine C - User-Defined Terminal Assignment

6 I/O terminals
6.3 User-defined terminal assignment
114
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.3 User-defined terminal assignment
In order to individually adapt the preconfigured assignment of the input/output terminals to your
application, you can choose one of the following procedures:
A. In the »Engineer«:
• Change the terminal assignment on the Terminal assignment tab.
• Change the signal assignment on the Application Parameters tab, on the dialog level
Overview  Signal flow.
B. In the »Engineer« or with the keypad:
• Change the parameters for signal configuration in the parameters list.
 Tip!
First set a suitable Lenze configuration by selecting a corresponding control mode in C007
.
We recommend using the »Engineer« for the implementation of comprehensive user-defi-
ned drive solutions.
 Note!
If you change the preconfigured assignment of the input/output terminals, the terminal
assignment will be a user-defined one. In C007
, control mode "0: Interconnection chan-
ged" will be shown.