8400 StateLine C | Reference manual
Basic drive functions (MCK)
Speed follower
360 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
8.3 Speed follower
The 8400 StateLine controller only supports the "Speed follower" operating mode, in which
the drive follows a speed setpoint.
8.3.1 Parameter setting
Short overview of parameters for the "speed follower" operating mode:
In the »Engineer», you can set the initial limit by means of the dialog box Min/Max speed.
Open the Min/max speed dialog box by opening the Application Parameters tab and
clicking on the following button on the dialog level Overview Signal flow:
Parameter Info Lenze setting
Value Unit
C02610/2 MCK: Ramp time synchr. setpoint 2.000 s
C02611/1
MCK: Pos. max. speed 199.99 %
C02611/2
MCK: Pos. min. speed 0.00 %
C02611/3
MCK: Neg. min. speed 0.00 %
C02611/4
MCK: Neg. max. speed 199.99 %
To Next Page
Loading...
