Lenze 8600 series - Setting of the Torque Controller

Block diagram
-
Field
frequency
Conditions
l
The torque control tan only be used in the motor mode and in
the armature setting range (range of constant motor excitation
from 0 to V/f-rated frequency).
l In this configuration, only one motor tan be connected.
l The torque control has an Optimum effect only with activated
magnetization current control (CO06 = -1-) .
10.2 Setting of the torque controller
Activation of the torque control
The torque control is activated via CO05 = -2O- (analog setpoint) or
CO05 = -21- (digital setpoint).
l CO05 = -2o-:
- analog setpoint frequency entered via terminals 7/8
- analog additional setpoint entered via terminals 1/2
- analog setpoint torque entered via terminals 3/4
l c005=21:
- digital frequency setpoint entered via digital frequency
input X5
- analog additional setpoint entered via terminals 1/2
- analog torque setpoint entered via terminals 3/4
A simultaneous torque control is not possible in the configuration
“torque control” since the torque setpoint must be entered via
terminals 3 and 4.
-.
123