Lenze 8600 series - Selection of the Brake Resistor

6.1 .l Selection of the brake resistor
l The following combinations ensure
- a maximum braking time of 15 seconds
- a maximum relative duty time of 10%.
l The set continuous power of the controller is the reference for the combination.
Operation at rated power (factory setting)
8602 8603 8604 8605
370 240 180 180
0.15 0.2 0.3 0.3
ERBM370R150W ERBM370R150W ERBM240R200W ERBDl80R300W ERBDl80R300W
8607 8608 8609 8610
100 68 47 33
0.6 0.8 1.2 2.0
ERBDlOOR600W ERBDlOOR600W ERBD068R800W ERBD047ROl K2 ERBD033R02KO
8612 8613 8614 8615
22 15 15 15
-
3.0 4.0 4.0 4.0
ERBD033R02KO ERBD022R03KO ERBD015R04KO ERBD015R04KO ERBDOl5R04KO
Operation at increased power
8602 8603 8604 8605
240 180 180 180
0.2 0.3 0.3 0.3
ERBM37OR150W ERBM240R200W ERBD180R300W ERBD180R300W ERBD180R300W 1
8607 8608 8609 8610
100 47 33 33
0.6 1.2 2.0 2.0
ERBDl OOR600W ERBDlOOR600W ERBDO47ROl K2 ERBD033R02KO ERBD033R02KO
Controller
F
8611 8612 8613 8614 8615
t e
ResistancelR 33 15 15 15 15
Power/kW 2.0 4.0 4.0 4.0 4.0
Order no. ERBD033R02KO ERBD015RO4KO ERBD015RO4KO ERBD015R04KO ERBD015R04KO
-
Operation at maximum power
8602 8603 8604 8605
180 180 180 -
0.3 0.3 0.3 -
ERBM240R200W ERBD180R300W ERBD180R300W ERBD180R300W -
Controller 8606 8607 8608 8609 8610
type
Resistance/Q 100 - 33 33 33
Power/kW 0.6 - 2.0 2.0 2.0
Order no. ERBDl OOR600W -
ERBD033R02KO ERBD033ROZ’KO ERBD033R02KO
t e
E Controller Resistanceli2 Power/kW 8611 - - 8612 4.0 15 8613 4.0 15 8614 4.0 15 - 8615 -
Order no. -
ERBDOI 5R04KO ERBDO15R04KO ERBDOI 5R04KO -
A higher brake power tan be obtained by using other resistors or by connecting several
resistors in parallel or in series. However, the minimum resistance given on page 38 must
be maintained!
39