Lenze 8600 series - Page 59

The arrow Position marks whether you are in the code or in the
Parameter level.
v Press, until CO1 1 is displayed
EL ” ’
+ C ‘0 ‘1 ‘1 ’ ’ ’ ‘5 ‘0 ‘. ‘0 ’ ‘H ‘z ’
m a. x f ‘r ‘e lq 1~ Ie In Ic ly 1 1
Press PRG to Change to the Parameter level
’ -3 ’ ’
5 ‘0 ‘. ‘0 ’ ‘H ‘z ’
f ‘r ‘e ‘q ‘u ‘e ‘n ‘c ‘y ’ ’
APress, until 60 Hz is displayed
C’O’l ‘1 ’
IE’ ” ’
’ -3 ’ ’ 6 ‘0 1. ‘0 ’ ‘H ‘z ’
m a x f ‘r ‘e ‘q ‘u ‘e ‘n ‘c ‘y ’ ’
-
The maximum field frequency of 60Hz is now set and is accepted
immediately.
Acceptance with SH + PRG
The controller accepts a new Parameter when SH+PRG are
pressed. This is possible even when the drive is running.
First press SH and then in addition PRG. The display Shows --ok--
for 0.5 seconds. The controller now works with the new Parameter.
The key combination SH and PRG tan be compared to the “return”
key on your Computer keyboard.
If yolu have to set a Parameter in this way, the programming tables
show the Symbol SH + PRG.
-
Acceptance with SH + PRG with controller inhibit
The controller accepts the new Parameter when the controller has
been inhibited before pressing SH + PRG.
Inhibit the controller, e.g. by pressing STP.
First press SH and than in addition PRG. The display Shows --ok--
for 0.5 seconds. The controller works with the new Parameter
when controller inhibit is cancelled.
If you have to set a Parameter in this way, the programming tables
show the Symbol [SH + PRG].
Lenze
57