Lenze 8600 series - I Controller Enable; Quick Stop; Select Direction of Rotation

3.1 .l Controller enable
Depending on the selected operating mode (Cool) different
procedures are necessary to enable the controller.
Terminal control, i.e. CO01 = -O-, -2-, -4-
l Apply a voltage between 13 and 30V across terminal 28.
l If you have pressed the STP key, enable the controller with SH
+ STP in addition.
In case of terminal control, CO40 serves as a display:
l CO40 = -0- means controller is inhibited.
l CO40 = -l- means controller is enabled.
Control via keypad, i.e. CO01 = -l-
* Apply a voltage between 13 and 30V across terminal 28.
l If you have pressed the STP key, enable the controller with SH
+ STP in addition.
l If you have set CO40 to -0- via the keypad, enter CO40 = -1- to
enable the controller as weil.
Code Name Parameter (Factory setting is printed in bold)
CO40 Controller Q Controller inhibited/inhibit
enable
-l- Controller enabled/enable
Acceptance
SH + PRG
Control via LECOM, i.e. CO01 = -3-, -5-, -6-, -7-
* Apply a voltage between 13 and 30V across terminal 28.
l If you have pressed the STP key, enable the controller with SH
+ STP in addition.
l Send CO40 = -l- via the intetface which has been selected for
control
3.1.2 Quick stop / Select direction of rotation
Quick stop
The quick stop function (QSP) serves to decelerate the drive to
standstill as fast as possible. For this, a deceleration time tan be
set which is independent of the normally required deceleration
times. It tan be set via Cl 05.
Code Name Parameter (Factory setting is printed in bold) Acceptance
Cl05
Deceleration 5.0 s 0.00 s
110 ms) 1 .OO s ON-LINE
time for quick 1 .o s (100 ms) 10.0s
stop 10s
11 SI
100s
100s
UOI
990 s
Quick stop tan always be activated via the terminals 21 and 22
(LOW Signal at both terminals), independently of the selected
operating mode (Cool).
When switching on the controller a HIGH Signal (from terminal 20
or external supply) is applied at terminals 21 and 22 the dnve is at
standstill with the function “QSP”.
In case of terminal controi, CO42 serves as a display:
l CO42 = -O- means, quick stop is not active,
l CO42 = -l- means, quick stop is active.
-
-.
-
60