Lenze 8600 series - Digital Frequency Output X9 (Option)

5.6 Digital frequency output X9 (Option)
-
The connection of drives via digital frequency allows a simple and
precise control of multi-motor Systems. The digital frequency output
X9 tan be used here as digital frequency encoder, e.g. for parallel
or Slave drives.
Assignment of socket X9
Pin
1
2
3
4
5
6
7
8
9
--
Name
5
A\
A
_-_
GND
--_
InputlOutput
output
*Output
output
“__
5V
B\
output
output
Explanation
2nd encoder Signal
1st encoder Signal inverse
1 st encoder Signal
Not used
Internal ground
Not used
Nt used
Lamp check
2nd encoder Signal inverse
Depending on the relationship of the drive controlled via X9, you
tan program under CO08 if the input Signals at X5 are to be output
unch,anged or if an internal setpoint Signal is to be processed.
Internal setpoint sources are:
l Main setpoint (Setpoint I/JOG frequency)
0 Ramp generator output (main setpoint)
l Total setpoint
l Output frequency
If you have selected an internal setpoint Signal as digital frequency,
you tan also program its setting range under CO30. The frequency
of the output Signals results from
Output freq. = setpoint Signal max. field freq. (CO1 1) constant (CO30)
Please note that when processing the selected setpoint Signal
minor conversion errors may be possible.
Parameter (Factory setting is printed in bold)
Output Signal -O-
Output of input Signals at X5
-2- Main setpoint (C046IJOG)
frequency 03
Ramp generator output
(main setpoint)
-5 Total setpoint
-200. Display value of CO50
-l-
512 pulses/Hr or incrementslrev.
-2- 1024 pulses/Hz or incrementslrev.
-3-
2048 pulses/Hz or increments/rev.
-4-
4096 pulses/Hz or incrementslrev.
Acceptance
SH + PRG
SH + PRG
95