Lenze 9300 Series - Page 330

Configuration
Code table
8
8.5

8.5−42
EDSVF9383V EN 4.0−03/2006
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0715 Function 0
Function selection, function block
TRANS2
See System
Manual
(extension)
0 Rising trans Rising edge 1. LOW−HIGH edge at TRANS2−IN
switches TRANS2−OUT = HIGH
2. After the time has elapsed
(C0716), TRANS2−OUT switches
to LOW
1 Falling trans Falling edge 1. HIGH−LOW edge at TRANS2−IN
switches TRANS2−OUT = HIGH
2. After the time has elapsed
(C0716), TRANS2−OUT switches
to LOW
2 Both trans Both edges 1. LOW−HIGH or HIGH−LOW edge
at TRANS2−IN switches
TRANS2−OUT = HIGH
2. After the time has elapsed
(C0716), TRANS2−OUT switches
to LOW
C0716 Pulse T 0.001 0.001 {0.001 s} 60.000 Pulse duration, function block
TRANS2
l After the time has elapsed,
TRANS2−OUT switches to LOW
C0718

CFG: IN 1000 FIXED0  Selection list 2 Configuration of digital input
signal, function block TRANS2
C0719 DIS: IN 0 1 Function block TRANS2
l Display of the signal linked in
C0718
C0720 Function 2
Function selection, function block
DIGDEL1
See System
Manual
(extension)
0 On delay On delay 1. LOW−HIGH edge at DIGDEL1−IN
starts a timing element
2. After the time has elapsed
(C0721), DIGDEL1−OUT
switches to HIGH
1 Off delay Off delay 1. LOW−HIGH edge at DIGDEL1−IN
starts a timing element and
sets DIGDEL1−OUT = HIGH
2. After the time has elapsed
(C0721), DIGDEL1−OUT
switches to LOW
2 ON/OFF delay On/off delay 1. LOW−HIGH or HIGH−LOW edge
at DIGDEL1−IN starts a timing
element
2. After the time has elapsed
(C0721),
DIGDEL1−OUT = DIGDEL1−IN
C0721 Delay T 1.000 0.001 {0.001 s} 60.000 Delay time, function block
DIGDEL1
C0723

CFG: IN 1000 FIXED0  Selection list 2 Configuration of digital input
signal, function block DIGDEL1
C0724 DIS: IN 0 1 Function block DIGDEL1
l Display of the signal linked in
C0723