Lenze 9300 - Page 127

Contents
v
L EDSVS9332P-D21 EN 3.0
7.5.70 Phase integrator (PHINT) 7-250....................................................
7.5.70.1 Constant input value 7-251..............................................
7.5.70.2 Scaling of PHINTx-OUT 7-252............................................
7.5.71 First order delay element (PT1) 7-253................................................
7.5.72 CW/CCW-QSP link (R/L/Q) 7-254...................................................
7.5.73 Ramp function generator (RFG) 7-255...............................................
7.5.73.1 Calculation and setting of the times Tir and Tif 7-256..........................
7.5.73.2 Loading of the ramp function generator 7-256................................
7.5.74 Sample and hold function (S&H) 7-257...............................................
7.5.75 Phase value selection (SELPH) 7-258................................................
7.5.76 Switching points (SP) 7-260.......................................................
7.5.76.1 Switching points 7-262.................................................
7.5.76.2 Hysteresis 7-263.....................................................
7.5.76.3 Dead time 7-264.....................................................
7.5.76.4 Filter time constant 7-265..............................................
7.5.77 Output of digital status signals (ST AT) 7-266...........................................
7.5.78 Control of a drive network (STAT E-BUS) 7-267.........................................
7.5.79 Multi-axis synchronisation (SYNC1) 7-268............................................
7.5.79.1 Possible axis synchronisations 7-269......................................
7.5.79.2 Cycle times 7-271....................................................
7.5.79.3 Phase displacement 7-273..............................................
7.5.79.4 Time slot for synchronisation via terminal 7-273..............................
7.5.79.5 Correction value of the phase controller 7-274...............................
7.5.79.6 Fault indications 7-274.................................................
7.5.79.7 Configuration examples 7-275...........................................
7.5.79.8 Scaling 7-275.......................................................
7.5.80 Teach-in in programming (TEACH) 7-276.............................................
7.5.81 Edge evaluation (TRANS) 7-278....................................................
7.5.81.1 Evaluate positive edge 7-279............................................
7.5.81.2 Evalute negative edge 7-279............................................
7.5.81.3 Evaluate positive or negative edge 7-280...................................
7.5.82 Variable table - acceleration (VTACC) 7-281...........................................
7.5.83 Variable table Piece number (VTPCS) 7-283...........................................
7.5.84 Variable table - target position/position values (VTPOS) 7-285..............................
7.5.85 Variable table Waiting time (VTTIME) 7-287............................................
7.5.86 Variable table - speed (VTVEL) 7-289................................................
7.6 Monitoring 7-291......................................................................
7.6.1 Reactions 7-291...............................................................
7.6.2 Set reactions 7-292.............................................................
Show/Hide Bookmarks