Lenze E84DGFCG Series - Page 55

I/O data transfer (implicit messages)
I/O configuration in the »Engineer«
55
Lenze · Decentralised frequency inverter 8400 motec (EtherNet/IP™ option) · EDS84DMOTEIP EN 2.0 - 10/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
For some data words, you can also assign signals to the individual bits via the and
buttons.
 Select the signals and then confirm the selection with OK.
5. Use the standard device code C00002 to execute the command "11: Save all parameter
sets".
The changed settings are activated and saved with mains failure protection.