Lenze · Inverter Drive 8400 motec (PROFINET® option) · DMS 5.0 EN · 02/2019 · TD23 15
3 Product description
3.3 Connections and interfaces
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• By default, the PROFINET connections and the LEDs for the PROFINET status displays are already
mounted and wired:
• PROFINET port 1 at plug connector X31
• PROFINET port 2 at plug connector X32
• LEDs on plug connector X55
• It is also possible to connect the PROFINET and other inputs and outputs (e.g. digital inputs) via
the positions A1 ... A4 and B1 ... B4.
• For the connections, 5-pin M12 connectors or - alternatively - cable glands (cable cross-section
max. 1.0 mm
2
, AWG 18) can be used.
• The M12 connectors, cable glands and prefabricated system cables can be obtained from
various manufacturers.
• Wire the M12 connectors or cable glands used to the corresponding contacts of the terminal
strips/plug connectors X3, X4 and X61.
"Inverter Drives 8400 motec" hardware manual
Observe the notes and wiring instructions contained in this documentation.
To Next Page
Loading...
