Lenze ECSES Series - Page 470

Index14
470
EDBCSXS064 EN 4.0
B
Basic identifier, 460
Baud rate
− setting, 171
via DIP switch, 171
− system bus (CAN). Siehe baud rate
Brake, connection, 62
Brake configuration, 102
Brake resistor, external, 464
− assignment, 464
− connection, 60
− type ERBD..., rated data, 464
− type ERBM..., rated data, 464
− type ERBS..., rated data, 465
Brake resistor, internal, Connection, 58
Bus cable length, 84
Bus load CAN, 189
Bus off, 199
C
Cable cross−section, 84
Cable cross−sections
− Control connections, 55 , 68
− control connections, 53
− control terminals, connection "Safe torque off", 74
Cable specification, 82
Cables, shielded, 54
Cables, specification, motor cables, 61
CAN bus
− assignment of the plug connectors, 82
− boot−up time setting, 176
− communication, 442
− configuring, 169
− cycle time setting, 176
− cyclic process data objects, synchronisation, 452
− data telegram, 442
− delay time setting, 176
− determining the master in the drive system, 175
− event−controlled process data objects, 453
− function blocks
CAN (CAN management), 267
CAN1In, 273
CAN1Out, 276
CAN2In, 282
CAN2Out, 285
CAN3In, 288
CAN3Out, 291
CANSync, 270
− identifier, 442 , 460
display code, 460
− Individual addressing, 173
− making a reset node, 178
− network management data, 443
− parameter data, 443 , 454
− parameter data channels, 454
− parameter data objects, addressing, 460
− process data, 443
− process data objects, 447
addressing, 460
data transmission, 450
− process data telegrams, 448
− setting baud rate, 169
− setting node address, 169
− user data, 443 , 455
CAN bus load, 189
CAN bus status, 187
CAN data telegram, 442
CAN diagnostic codes, 187
CAN management, 186
CAN management (function block), 267