Lenze g500-B600 - Page 57

Gearbox G50BB160 ... G50BB320
How to check the lubricant level:
1.
Remove the control screw at the marked posion.4Venlaon ^ 23
2.
Insert auxiliary tool through the threaded hole.
3.
Carefully pull out the auxiliary tool and determine the lubricant level. The lubricant level
may be between the threaded hole and dimension "x".
4.
If the lubricant level is too low, top up lubricant unl the lubricant level is in the marked
area. If the loss is greater, determine the cause.
5.
Insert the control screw and ghten it to the specied torque.
d2
G
x
ÖL
90°
A
B
C
A Check bore hole
B Auxiliary tool, e. g. angled wire (not included in the scope of supply)
C Control screw
Threaded hole G Screw head Filling height x
mm mm
M10 x 1 14 2
M12 x 1.5 17 3
M16 x 1.5 21 4
M20 x 1.5 25 5
G 1/8" 14 2.5
G 1/4" 18 3
G 3/8" 22 4
G 3/4" 32 7
Maintenance
Maintenance work
57