Lenze I/O system 1000 - Page 42

Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17 42
3 Configuring the I/O system in the »Engineer«
3.2 Mapping the real station layout in the »Engineer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13. Add more electronic modules.
•Use the Select New Module button to put the selected electronic module to the end.
•Use the Insert Module button to insert the selected electronic module in front of the
marked module.
•Use the Cut button to remove the marked electronic module.
•Use the Paste button to insert the electronic module cut before in front of the marked
module.
•Use the Duplicate button to copy the marked electronic module and insert it in front of it.
•Use the Delete button to delete the marked electronic module.
•Use the  buttons to move the marked electronic module to the right or left.
14. Click the Complete button.
Then, an I/O system 1000 may look as follows:
• You can now make the required parameter settings offline.
Parameterising I/O modules in the »Engineer«
( 45)
• Then, go online to transmit the parameter settings made in the »Engineer« to the I/O
system 1000.
Setting the communication path and going online
( 43)