Lenze I/O system 1000 - Page 61

4 Configuring the I/O system in the »PLC Designer«
4.3 Mapping the real station structure in the »PLC Designer«
61
Lenze · I/O system 1000 · Reference Manual · DMS 5.0 EN · 09/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Adding I/O compound modules to the CANopen bus coupler module
10. Select the "EPM_S110" device in the device view:
11. Select the physically first I/O compound module in the Add Device dialog box and add it to
the device view by clicking the Add device button.
12. Proceed as described before to add all other available I/O compound modules of the Device
view.
• Sample representation:
13. Click the Close button to close the Add Device dialog box again.