Lenze Motec 8200 - Page 126

8
Fault detection and elimination
Fault messages
EDK82MV371 DE/EN/FR 6.0
L
124
Keypad RemedyCauseErrorPC
1)
ce0

61 Communication
fault to AIF
(configurable in
C0126)
Faulty transmission of control
commands via AIF
Insert the communication module
into the hand terminal
ce1

62 Communication
fault to CAN−IN1
with Sync control
CAN−IN1 object receives faulty
data or communication is
interrupted
l Plug−in connection − bus
module
ó Check FIF
l Check transmitter
l Increase monitoring time under
C0357/1 if necessary
ce2

63 Communication
error to CAN−IN2
CAN−IN2 object receives faulty
data or communication is
interrupted
l Plug−in connection − bus
module
ó Check FIF
l Check transmitter
l Increase monitoring time under
C0357/2 if necessary
ce3

64 Communication
error to CAN−IN1
with event or time
control
CAN−IN1 object receives faulty
data or communication is
interrupted
l Plug−in connection − bus
module
ó Check FIF
l Check transmitter
l Increase monitoring time under
C0357/3 if necessary
ce4

65 BUS−OFF
(many
communication
faults occurred)
Controller has received too
many incorrect telegrams via
the system bus and has been
disconnected
l Check whether bus terminator
available
l Check screen contact of the
cables
l Check PE connection
l Check bus load, if necessary,
reduce the baud rate
ce5

66 CAN Time−Out
(configurable in
C0126)
For remote parameter setting
via system bus (C0370):
Slave does not answer.
Communication monitoring
time exceeded.
l Check system bus wiring
l Check system bus
configuration
For operation with application
I/O:
Faulty parameter setting of
parameter set changeover
In all parameter sets the signal
"parameter set changeover"
(C0410/13, C0410/14) must be
combined with the same source
For operation with module in
FIF:
Internal fault
Contact Lenze
ce6

67 Function module
system bus (CAN)
on FIF has set
"Warning" or
"BUS−OFF"
(configurable in
C0126)
CAN controller sets "Warning"
or "BUS OFF"
l Check whether bus terminator
available
l Check screen contact of the
cables
l Check PE connection
l Check bus load, if necessary,
reduce the baud rate
efesotomasyon.com - Lenze