Lenze Motec 8200 - Initial Commissioning: 8200 Motec without Function Module

Commissioning − 8200 motec without function module
l The 8200 motec can only be used when the FIF
cover is mounted! ! (as delivered).
– Without FIF cover the 8200 motec is inhibited
(keypad:
).
l Since the 8200 motec does not provide any control
terminals when the function module is not attached,
starting and stopping during operation is possible by
switching the mains.
l Function  stores the setpoint at the time when
operation is interrupted by switching the mains or
mains failures. The drive restarts automatically as
soon as the mains connection is built up again.
l If the drive does not start in step   is not off),
press
 to enable the 8200 motec.
8200mot041
A
8200mot042
L1/L2/L3/N/PE
W
2
U
2
V
2
U
PE
1
V
1
W
1
w
j
y
0....- 50 Hz
z
0....+50 Hz
z
y
wx
v
t
u
s
5000
cd
j
Hz
0
1
40
3
1
2
AIF
z
y
wx
v
t
u
s
88888
8888
888
8
a bcde
j gfkih PS 
 mno
p
qr
Hi
Hz
%sh
rpm
°C
Ω
m
AV
Lo
E82ZBB
E82ZWLxxx
Step Note see chapter

Connect the hand
terminal (with keypad)
with the motec. Plug the
connector of the cable
into the AIF interface at
the motec.
Hand terminal and connection cable are not included in the
delivery package.
7

Switch on the mains
voltage.
Self start possible!
The controller is ready for operation after approx. 1
second.
Keypad: 

Select the setpoint via
the function .
 activate   
CW rotation 
 is off. The drive should be
running now.
Display indicates output frequency.
CCW rotation 
Any faults or errors during commissioning or operation?
efesotomasyon.com - Lenze