Lenze SX-1 - 6.2 Modes of Operation - Software Version 5.XX; Remote Control Modes; Manual External Mode; Automatic External Mode

__________ _________________-— 6.2
6.2 Modes of Operation - Software Version 5.XX
Operating Mode selection and Function with Software Version 5.XX
1. External Remote
Control is from the PT-1 or EPAS, using the serial communication link. The Manual, Home,
Automatic and Continuous modes are available.
This mode is selected by input E8. SX-1 displays „d“ on the 7-segment display. Input ES
starts and stopsthe movement of the axis: ES = High continuesthe program, and ES = Low
interrupts the program.
IMPORTANT:
With Remote control, there is no supervision of the communications link: securityfunctions
must be performed with inputs El and ES.
2. Manual External
In this mode, the drive may be moved continuously in eitherdirection. The speed is preset
using Parameter P 08 „Manual-SIow“. This mode is selected by input E6. SX-1 displays
„H“. Movement in negative direction is selected by E 09 = high (axis report „-„) and in
positive direction by E 10 = high (axis report „-1“).
Homing is initiated by E 11 (axis report „r“). When the reference switch, input E 4, is active
high, axis report „ir“ is shown, and when the reference pulse is received, axis report zero
„0“ is shown.
To enable all functions, input E 05 must be active (high).
3. Automatic External
In this mode, it is possible to initiate automatic Operation of a sequence using the I/O
controls. The Number of the program is preselected by Parameter PO.
This mode is selected by E 7. SX-1 displays „A“.
The program is started and interrupted by input E 5.
In the automatic mode, the inputs E 9, E 10 and El 1 are available as 1001,1002 and 1003
for the application program.
6/4 —_________________ ____
Lenze