Notice
If no data transmission takes place (e.g. TX in "O" status),
all 8 outputs are set to "O".
Output enable input (OE) If a "l" is applied at this input, the outputs are switched to the active operation
status, i.e. it is possible for received signals to be read out. A "0" at this input re-
sults in "0" at all the outputs and the green indicator LEDs.
Benefits The status of output drivers can easily be automatically checked by a programm-
able control system. "O" at the OE generally forces a signal change at the outputs.
10 DLSP 160S Leuze electronic
To Next Page
Loading...