How to resolve an external fault in Leuze electronic Lighting Equipment?
If there's an external fault with your Leuze electronic Lighting Equipment, check the connection of the cables and the control signals.
What to do if reset button actuation duration exceeded on Leuze electronic MLC 520 EX Lighting Equipment?
If the actuation duration (2.5 min) has been exceeded for the reset button or the cable is short-circuited on your Leuze electronic Lighting Equipment, press the reset button. If the restart is unsuccessful, check the wiring of the reset button.
Why did the operating mode change on my Leuze electronic MLC 520 EX Lighting Equipment?
If the operating mode has changed on your Leuze electronic Lighting Equipment, check the wiring and restart the sensor.
What to do if alignment is incorrect on Leuze electronic Lighting Equipment?
If the alignment of your Leuze electronic Lighting Equipment is incorrect or the protective field is interrupted, remove any objects obstructing the protective field. Then, align the transmitter and receiver correctly. If you're using blanked objects, ensure they are correctly positioned according to their size and location.
What to do if EDM does not open on Leuze electronic MLC 520 EX?
If the EDM (External Device Monitoring) does not open on your Leuze electronic Lighting Equipment, actuate the start button if available.
What to do if EDM does not close on Leuze electronic Lighting Equipment?
If the EDM (External Device Monitoring) does not close on your Leuze electronic Lighting Equipment, actuate the start button if available.
How to check cross connection between OSSD1 and OSSD2 on Leuze electronic MLC 520 EX?
If there is a cross connection between OSSD1 and OSSD2 in your Leuze electronic Lighting Equipment, check the wiring between them.
What causes overload on OSSD1 in Leuze electronic MLC 520 EX Lighting Equipment?
If there is an overload on OSSD1 in your Leuze electronic Lighting Equipment, check the wiring or exchange the connected component to reduce the load.
What causes overload on OSSD2 in Leuze electronic MLC 520 EX?
If there is an overload on OSSD2 in your Leuze electronic Lighting Equipment, check the wiring or exchange the connected component to reduce the load.
How to fix short circuit against GND at OSSD1 on Leuze electronic MLC 520 EX Lighting Equipment?
If there is a short circuit against GND at OSSD1 in your Leuze electronic Lighting Equipment, check the wiring and exchange the cable if applicable.
General| Brand | Leuze electronic |
|---|---|
| Model | MLC 520 EX Series |
| Category | Lighting Equipment |
| Language | English |
To Next Page
