LevelOne IES-0600 - Page 2

IES-0600
Power Input
Terminal Block
PW1
PW2
Relay Output
Power Input
+
12
–
55
VDC
–
Power Ground
+
12 – 55VDC
–
Power Ground
Relay Output
1A @ 24VDC
Page 4 IES-0600
DIP Switch
OFF
T5 (RJ45) enabled
ON
F5 (SFP) enabled
Note:
Port5 (T5 & F5) is shared combo port
RJ45 or SFP via DIP1 switch
DIP Switch
DIP1
DIP1
T5 (RJ45) enabled
1000M
F5 (SFP) enabled
100M
Port5 (T5 & F5) is shared combo port
, enable either
RJ45 or SFP via DIP1 switch
Page 5
DIP1
1000M
100M
, enable either
IES-0600
DIN Rail Mount
•
Assembly: Place the switch on the DIN rail from above using
the slot. Push the front of the switch toward the mounting
surface until it audibly snaps into place
• Start-
up: Connect the supply voltage to start up the switch
via the terminal block (or DC JACK)
•
Dismantling: Pull out the lower edge and then remove the
switch from the DIN rail.
DIN Rail Mount
Assembly: Place the switch on the DIN rail from above using
the slot. Push the front of the switch toward the mounting
surface until it audibly snaps into place
up: Connect the supply voltage to start up the switch
via the terminal block (or DC JACK)
Dismantling: Pull out the lower edge and then remove the
switch from the DIN rail.
Page 6
Assembly: Place the switch on the DIN rail from above using
the slot. Push the front of the switch toward the mounting
up: Connect the supply voltage to start up the switch
Dismantling: Pull out the lower edge and then remove the
IES-0600
10/100/1000Base
The following lists the
Pin
10/100 DC & Data
1
Rx + DC +
2
Rx -
3
T
x + DC
4
unused
5 unused
6 Tx -
7 unused
8 unused
10/100/1000Base
-
TX Pin
The following lists the
pin-out of 10/100/1000Base
-
10/100 DC & Data
1000
DC & Bi
Rx + DC +
TxRx A + DC +
DC + TxRx A -
x + DC
-
TxRx B + DC
TxRx C +
TxRx C -
DC - TxRx B -
TxRx D +
TxRx D -
Page 7
TX Pin
-
TX ports
DC & Bi
-
Data
TxRx A + DC +
DC +
TxRx B + DC
-
DC -